Weekend Whimsy Wreath

Burlap Wreath Directions:Wrap the wreath with burlap, hot glue as you go.
Once the wreath covered,use your designer Templates to create the flowers. Once that is done hot glue them and any other embellishments you would like to add to the wreath.


If you want to add a letter like I did, simply mod podge paper to the top
and use an emery board to sand the edges.

Basic Flower: Begin by tracing the template that you would like to use. Once
you have cut the shape out, cut the entire shape into a swirl like you see
above.



Pinch and fold the flower from the inside/middle of shape, hot gluing as you go to create the flower you would like.

Bracket Flower: Tiny Sweetheart Bracket - Once you have traced and cut the piece, fold and hot glue until you have created the above petal. Make 3 and then hot glue together. Add a center to finish the look.
Give your leaves some dimension by slitting the stem and folding it over.
To create a more ruffled flower, cut a circle out using the Rings Acc. Set. Then Starting in the middle, fold and hot glue as you go along. Make sure to start this one at the outside edge of the center of the shape you have cut.